Ariat Western Riding Boot CHALLENGER 18695 Branding Iron Brown Brindle - Braun!
Classic men riding boots of the Ariat brand with foot stabilizing ATS PRO technology!
The complete interior was worked out with a soft leather.
The heel area was equipped with a cow split leather to optimize the hold.
ATS PRO technology:
ATS Technology is a foot stabilizing and cushioning footbed. Instead of the classic metal spring, a lighter fork joint support is used.
The special fork support maintains balance, reduces muscle fatigue (thanks to torsional stability) and injuries. In addition, the support allows natural flexibility in the forefoot area.
The special footbed has a moisture-repellent coating that keeps the feet dry and at the same time has an antibacterial effect. The low-friction surface reduces the formation of heat and blisters.
The gel spring system in the forefoot area serves as a shock absorber and relieves the important pressure points. The pressure on knee, hip and back is reduced and the rolling comfort is additionally increased. The heel cup stabilises and supports the foot.
The upper material for the Ariat CHALLENGER 18695 welted western riding boot is a very robust, waxed cowhide leather with a full grain look (FULL GRAIN).
The waxing of the leather gives each boot a very distinctive look. The upper is embroidered with classic decorative seams and is also made of cowhide leather.
Two pull straps have been incorporated to make it easier to get started.
The boot has an approx. 0.7 cm deep spore edge made of plastic, which is ideal for attaching spores.
The abrasion-resistant DURATREAD Outsole outsole from Ariat is sewn to the outer frame and increases the wearing comfort due to its special composition.
The boots have a square WIDE SQUARE TOE last.
The boots have a very good fit and instep height.
The Ariat CHALLENGER 18695 Branding Iron Brown Brindle Western Riding Boot has a shaft height of 11 inches (approx. 28 cm).
The DURATREAD sole is about 0.8 cm thick.
The HORSEMAN heel is 1.5 inches (approx. 3.8 cm) high.
The shaft has a circumference of approx. 36 cm. Depending on the shoe size, this can increase or decrease by 1-2 cm.
The boots have a D width (ARIAT/ Medium width for men).
Important hints and tips:
Due to the handcrafted production method of the Ariat products, differences in colour or technical design may occur compared to the illustrated boots!
Each pair of ARIAT boots is unique!
Waxed leathers (FULL GRAIN) also require special care products.
With the frame-sewn manufacturing method (GOODYEAR WELT) always a small running-in phase is to be considered!
Made in MEXICO
The spurs and spur straps shown are not included in the scope of delivery!